For an optimal result of your DUPLEX manicure, you should first prepare your natural nails:

Push back the cuticles. File the nails into shape with the manicure file. Clean and matt the nail surface with a nail buff. Then remove filing dust with a dry cloth and wipe the nail plate with Express Remover.

Step 1: 

Apply DUPLEX UV-BASE COAT in even brush strokes quickly from the center of the nail bed towards the nail tip. The nail polish brush, made of particularly fine nylon fibers, is slightly flattened, oval towards the tip, which facilitates precise application, even at the nail edges.

Step 2:

Immediately cure the Base Coat for 60 seconds in the POWER LED LIGHT after application. For devices with lower wattage, adjust the curing time accordingly. Ensure that all nails are evenly exposed to the UV light.

Make sure that the nails are positioned exactly under the LEDs in the LED lamp.

Step 3:

Apply a very thin layer of DUPLEX UV NAIL POLISH in even brush strokes quickly. The natural nail should ideally still be slightly visible after applying this layer.

Step 4:

Wrap the nail sprays. If nail polish gets on the skin, remove the color from the skin with a manicure stick BEFORE curing.

Step 5:

Place hands one after the other in the LED lamp and dry the nail polish for 60 seconds. Then apply a second thin layer and dry again for 60 seconds in the LED lamp. Make sure your fingernails are positioned exactly under the LEDs in the device.

Step 6:

Apply DUPLEX UV TOP COAT as a sealant in even brush strokes quickly.

Step 7:

Wrap the nail tips.

Step 8:

Then immediately cure for 2 x 60 seconds in the POWER LED LIGHT. The surface may still feel soft afterwards, as the light reaction of the UV nail polish is only fully completed after about 5 minutes. 

Only then will you achieve an optimal result and long durability:

> Make sure that your fingernails are always positioned exactly under the LEDs during curing in the device.

> The color layer must be applied thinly so that the coating cures well (otherwise it remains soft).

> The nails must always be positioned exactly under the LEDs in the rear part of the LED lamp.